Skip to page content

AEGLIX MIND

Connected intelligence.Security research, connected

AEGLIX vulnerability intelligence

CVE-2026-68469

UNSCORED · Received

Published: 2026-08-15 · Updated: 2026-11-06 · Source: NVD

Stored catalog record

Source record retrieved 2026-11-06T19:27:16.131394+00:00. Scheduled imports handle updates; this page does not assert that the provider was queried just now.

Continue your research

Connect this record to stored reporting, reviewed campaign mentions and source-domain investigation. These are research leads, not inferred attack relationships.

Open CVE research in Investigate · Find Arsenal listings referencing this CVE

Vulnerability overview

In the Linux kernel, the following vulnerability has been resolved: wifi: mwifiex: fix permanently busy scans after multiple roam iterations In order for the firmware to sleep, the driver has to confirm a previously received sleep request. The normal sequence of evets goes like this: EVENT_SLEEP -> adapter->ps_state = PS_STATE_PRE_SLEEP -> sleep-confirm -> SLEEP -> EVENT_AWAKE -> AWAKE. Before sending the sleep-confirm command, the driver must make sure there are no commands either running or waiting to be completed. mwifiex_ret_802_11_associate() unconditionally sets ps_state = PS_STATE_AWAKE when it processes the association command response, outside of the normal powersave management flow. If EVENT_SLEEP arrives while the association command is in flight, ps_state is PRE_SLEEP when the association command response is parsed, and the forced AWAKE overwrites it. The deferred sleep-confirm is never sent. A subsequent scan_start command is correctly acknowledged, but the firmware doesn't generate scan_result events. The scan request never finishes, and additional requests from userspace fail with -EBUSY. After testing on both IW412 and W8997, I could only trigger the bug on the IW412 and observed the firmwares behave differently. On the IW412 the firmware still sends EVENT_SLEEP while the authentication / association process is ongoing. A W8997 under the same conditions seems to suppress power-save for the duration of the association, so PRE_SLEEP never coincided with the association response even after extended periods of testing using the loops described below (>12hours). On the IW412, the delay between commands that triggers an EVENT_SLEEP was empirically determined to be ~20ms. This delay can naturally occur when the driver is outputting debugging information (debug_mask = 0x00000037), in which situation the busy scans issue is repeatable while running "test 1)" as described below. If the delay between commands is less than ~20ms, the firmware stays awake and the issue was not reproducible running the same test. The host_mlme=false path also behaves differently. In this case, the entire authentication / association transaction is executed by one command (HostCmd_CMD_802_11_ASSOCIATE), and the firmware doesn't emit EVENT_SLEEP while the command is running. Remove the assignment so the ps_state is only manipulated in the paths that are related to powersave event handling and on the main workqueue for correct sleep confirmation. The following loop tests were performed (with debugging output enabled): 1) force roaming between two AP's, one 5GHz and one 2.4GHz, same SSID. Use wpa_cli to trigger the roaming behavior, sleep 2s between iterations. 2) force a disconnection to AP 1 and a connection to AP 2, test scan. Use wpa_cli to trigger the connection changes, sleep 2s between iterations. Each test ran in each device for at least 3 hours.

Patch review priority

Assess exposure and vendor guidance

  • No higher-priority signal is available in the current stored evidence.

FIRST EPSS: 0.26% · percentile 18.4 · score date 2026-11-18.

EPSS estimates probability of exploitation in the next 30 days. It does not measure your exposure or prove exploitation. The elevated threshold is 10%; CISA KEV takes precedence. About FIRST EPSS ↗

Severity and scoring

CVSS score
Not scored · UNSCORED
CVSS version
Not supplied
CVSS vector
Not supplied
Weaknesses
Not supplied

CVSS measures technical severity; it does not establish whether this vulnerability is being exploited in your environment.

Known exploitation and remediation

Not listed in the CISA catalog retrieved for this record. This does not establish that exploitation has not occurred.

Verify affected versions and patch availability in the vendor advisory before making changes.

Affected products and versions

NVD has not supplied affected-version configurations for this record. Check the vendor references below.

Advisories and references

Explore official sources

Read the official NVD record ↗

Explore the CISA catalog ↗

Back to CVE intelligence