AEGLIX vulnerability intelligence
CVE-2026-93669
MEDIUM · CVSS 4.7 · Awaiting Analysis
Published: 2026-11-16 · Updated: 2026-11-17 · Source: NVD
Stored catalog record
Source record retrieved 2026-11-17T21:59:40.839296+00:00. Scheduled imports handle updates; this page does not assert that the provider was queried just now.
Continue your research
Connect this record to stored reporting, reviewed campaign mentions and source-domain investigation. These are research leads, not inferred attack relationships.
Open CVE research in Investigate · Find Arsenal listings referencing this CVE
Vulnerability overview
The ITE IT8xxx2 SHI host-command backend in subsys/mgmt/ec_host_cmd/backends/ec_host_cmd_backend_shi_ite.c arms the SPI peripheral before its receive context exists. shi_ite_init_registers() sets the state machine to SHI_STATE_READY_TO_RECV and calls irq_enable() while the device initializes at POST_KERNEL priority CONFIG_KERNEL_INIT_PRIORITY_DEFAULT (40), but data->rx_ctx and data->tx are only assigned later by shi_ite_backend_init(), which ec_host_cmd_init() invokes at CONFIG_EC_HOST_CMD_INIT_PRIORITY (default 80). If the attached host processor starts a SPI transaction inside that window, the Rx-valid-length interrupt fires, shi_ite_int_handler() passes its state check and calls shi_ite_parse_header(), which stores the host-derived request length through the still-NULL data->rx_ctx. On the IT8xxx2 low addresses are not backed by RAM, and with CONFIG_NULL_POINTER_EXCEPTION_DETECTION_PMP the first bytes of the address space are explicitly made inaccessible, so the store raises a fatal access fault in interrupt context. The window widens further when CONFIG_EC_HOST_CMD_INITIALIZE_AT_BOOT is disabled and the application calls ec_host_cmd_init() itself. The result is a kernel panic on the embedded controller: with Zephyr's default fatal handler the CPU halts, so the controller stops servicing host commands until a hardware reset. Because the trigger is traffic from the attached host processor -- an untrusted peer from the controller firmware's point of view -- software on that host can provoke the fault by forcing a controller reset and issuing transactions during the reboot, turning a recoverable reset into a persistent outage. Impact is limited to availability: the faulting address is fixed and not attacker-chosen, so no memory-corruption primitive follows. The fix leaves the interface at SHI_STATE_DISABLED with the interrupt masked during device init, moves irq_enable() into shi_ite_backend_init() after the buffers are published, and makes shi_ite_int_handler() reject a NULL data->rx_ctx while write-clearing IT83XX_SPI_ISR and IT83XX_SPI_RX_VLISR so that an unexpected early interrupt cannot storm.
Patch review priority
Assess exposure and vendor guidance
- No higher-priority signal is available in the current stored evidence.
FIRST EPSS: 0.09% · percentile 0.5 · score date 2026-11-18.
EPSS estimates probability of exploitation in the next 30 days. It does not measure your exposure or prove exploitation. The elevated threshold is 10%; CISA KEV takes precedence. About FIRST EPSS ↗
Severity and scoring
- CVSS score
- 4.7 · MEDIUM
- CVSS version
- 3.1
- CVSS vector
- CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:N/I:N/A:H
- Weaknesses
- CWE-476
CVSS measures technical severity; it does not establish whether this vulnerability is being exploited in your environment.
Known exploitation and remediation
Not listed in the CISA catalog retrieved for this record. This does not establish that exploitation has not occurred.
Verify affected versions and patch availability in the vendor advisory before making changes.
Affected products and versions
NVD has not supplied affected-version configurations for this record. Check the vendor references below.